How to use the 808 hair removal device - Gzosano.com

 How to use the 808nm hair removal device

1. Wipe the probe with alcohol cotton before and after the operation, and then wipe the probe with a cotton pad or soft cleansing cotton;

2. When the instrument is turned on, first turn on the dot switch, and then turn on the key switch.

3. Wait for more than 5 minutes to enter the first interface after the first boot, and then press the Enter key to enter the system. After the first boot, you only need to wait for 1-2 minutes, and then press the Enter key to enter the system.

4. When entering the system, the machine needs to run the water circulation cooling system to cool the treatment head (with water droplets condensing), wait for about 5 minutes and then press the ready to operate for the guests.

5. After waiting for 5 minutes, the customer‘s hair can be removed. Any part of the operation must be shaved. It does not need to be very clean. It is best to leave about 1mm of stubble to absorb light and the effect is good; Shave the hair completely at home in three days, and after two days, a little stubble will grow and come back to take off.

5. Apply the gel to relieve heat and dissipate heat. Apply a thin layer about the size of a coin. The gel can be refrigerated and then applied to improve the comfort.

6. After adjusting the parameters, try a few shots to see if the parameters are suitable; the hair removal energy should be adjusted to the best effect if the guest feels tingling heat;

Energy (J): 15-30, frequency (HZ): 1-3, water flow rate: above 1.3, water purity 00.0, water temperature (°C): below 25, probe temperature (°C): below 5.

Energy determines the effect and feeling of the customer. Generally, it is necessary to adjust the energy. The effect is better when the customer feels stinging heat, because the greater the acceptable energy, the better the effect, but it must be within the acceptable range of the customer. The whiter and lighter the hair color, the higher the energy, the darker the skin color and the darker the hair color, the lower the energy.

The frequency is how many times the light is emitted per second. If you adjust 3, it will emit 3 beams of light per second, and if you adjust 2, it will emit 2 beams of light per second. You can adjust 1-3 according to your own sliding speed.

Note: The amount of energy does not have to be adjusted properly, because different customers have different pain feelings, and different parts receive different energy. As long as the machine adjusts the part, skin color, and frequency to 3HZ, the machine will automatically adjust the energy. , if the energy automatically given by the machine hits the customer's skin, if it hurts, turn down the energy, 2-3 bars each time, and you can increase it if you don't feel it.

7. Operate large parts (such as the back, arms, thighs), use the sliding method, hold the probe close to the skin, press the handle switch and start to push at an even speed after the light is emitted, and operate about 5 times. (Do not stay on the same skin after the light is emitted)

8. Operate small parts, such as: hairline, lip hair and other techniques, use the stamping technique, hold the probe close to the skin, press the handle switch to emit light, and then light up, and then move to the next skin position, like stamping In the same way, the first light spot should be close to the next light spot during the operation to ensure that every place is hit, and the operation is about 5 times. After the operation, the light should not stay in the same skin position.

9. After the laser hair removal operation, wipe all the gel with a paper towel, and then use a cotton pad or a soft cleansing cotton towel to clean the probe to complete the operation.

Gold Standard 808 Diode Laser Hair Removal Machines, very worth to choose for beauty spa salon.